Publicidad
aSSeMBLY InSTrucTIonS
TooLS reQuIreD For aSSeMBLY
(2) Adjustable Wrench
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
(1) Rubber Mallet
Lay out and identify the parts and hardware using the
illustrations on page 3 and page 4.
aSSeMBLe The hITch MounT aSSeMBLY
STeP 1:
(See FIGure 1)
• Insert a slider tube (2) into each end of the hitch
mount assembly (6).
• Attach the slider tube to the hitch mount assembly
using two hex bolts (G), four washers (V), and two
Nylock hex nuts (N). Do not tighten.
G
V
6
V
N
2
2
FIGure 1
STeP 2:
(See FIGure 2)
• Attach the hitch mount assembly (6) to the tractor
frame using two U-bolts (4) secured with two mounting
brackets (3), four washers (U), and four hex nuts (P).
Do not tighten.
• If the slider tube does not fully extend into both U-bolts
(4), then loosen the appropriate hex bolt (G) and
reposition the slider tube (2).
• Center the hitch mount assembly on the tractor frame.
• Tighten all hex bolts and hex nuts.
note: Depending on your mower, U-bolts may need to be
installed at an angle.
P
U
3
4
2
6
G
6
FIGure 2
Publicidad
