Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Charge the Floorwasher
1.
Place the Floorwasher on the charging base.
2.
Connect the charging cable to the charging base and the power socket.
NOTE:
•
When charging, the battery level icon on the display panel animates
•
Make sure the Floorwasher is fully charged before use.
•
Place the charging base in a dry place.
Use the Floorwasher
Fill the clean water cup
Before using the Floorwasher, fill the clean water cup with tap water to the MAX line marked
on the cup. Do not allow water to exceed the MAX line.
NOTE: You can fill the cup with warm water; however, do not use water with
temperature over 60 degrees.
While pressing the clean water cup release button downward, pull to remove the cup.
Open the lid and fill the cup with tap water. Do not allow water to exceed the MAX line.
NOTE: You can fill the cup with warm water; however, do not use water
with temperature over 60 degrees.
Close the lid and make sure the cup is closed tight and no leakage.
Place the clean water cup back to the main body, and then push the cup in until it
clicks into place.
Power on the Floorwasher
1.
Press the On/Off button
2.
Tilt the Floorwasher backward to start cleaning.
NOTE:
•
When standing upright, the Floorwasher will be powered off even if you press
the On/Off button.
•
Do not tilt the Floorwasher over 140 degrees. Doing so might result in water
leakage from the water cups.
on the handle to power on the Floorwasher.
9
EN
.
Publicidad
