Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
Clean the main body
Make sure the Floorwasher is powered off before cleaning.
Clean the main body with a soft cloth. It can be slightly damp with clean water or
neutral detergent. Be caution not to get the internal components wet.
Clean and empty the dirty water cup
When the dirty water cup is full, the Floorwasher will turn off automatically. The Dirty
water cup full status icon
While pressing the dirty water cup release button, pull the cup out.
Remove the HEPA filter, the lid and the separator from the cup.
Empty the cup and clean the residues on the inner wall of the cup with the cleaning
brush provided. Then, rinse the cup clean.
If you find blockage in the dirty water cup, rinse the lid, the float and the separator
with tap water.
Clean the HEPA filter
We recommend that you clean the HEPA filter after each use.
Remove the HEPA filter from the dirty water cup.
Clean the filter under running tap water.
After cleaning, allow the filter to air dry.
Re-attach the dirty water cup
After cleaning, allow the cup, the HEPA filter, the lid and the separator to dry.
Place the separator, the lid and the HEPA filter back to the dirty water cup.
Insert the dirty water cup back to the main body. Push the cup in until it clicks into place.
will appear on the display panel.
13
EN
Publicidad
