Disarm; Stay Mode - Smanos WK8000 Manual De Funcionamiento

EN

Disarm

Users can disarm alarm system by pressing keypad or by using
RFID tags.
Using Keypad to Disarm
Input user code or admin code, and press
indicator flashes once and the keypad beeps once and sends
disarm signal to the control panel.
When the alarm panel receives the signal, the siren will beep twice
and the Disarm indicator will light on, the alarm system enters
disarmed state. In this state, the sensors being triggered will not
cause an alarm.
21
key, the LED
Using RFID Tag to Disarm
If direct disarm by RFID tag is disabled, user needs to press
wake up the keypad and then tap the RFID tag on reader to disarm
the system.
If direct disarm by RFID tag is enabled, user is able to tap the RFID
tag on the reader to disarm the system.

Stay Mode

Input user code or admin code, and press
indicator flashes once and the keypad beeps once and sends stay
mode signal to the control panel.
When the alarm panel receives the signal, the siren will beep once,
the alarm system enters stay mode state.
All the sensors in other zones are armed to prevent the intruder
except that the motion detector in Home Mode Zone is disarmed,
so people can move freely at home.
EN
[*] to
key, the LED
22