Installation - Smanos WK8000 Manual De Funcionamiento

EN
2. Press [9], one beep is heard and the LED indicator is on. Keypad
enters learning state.
3. Tap the RFID tag on the reader RFID reader, the connection
succeeds after one beep and the LED indicator goes out.
If two beeps are heard, it indicates the RFID tag has been connected before.
To clear the connection of all RFID tags, input
keypad and then press down [9]
deleted.
7
[admin code + #] to wake up the
for six seconds. All connected RFID tags will be

Installation

Before using the keypad to control the system, you have to install
it to the doorframe or on the wall.
Step 1, slide the cover of the RFID reader gently, loose four small
screws, open the lid of the battery compartment.
Step 2, loose the big screw on the right of the tamper until the
back bracket is out.
Step 3, fix the bracket to the target place with the screws, please
notice the direction ( mark upwards).
Step 4, aim the keypad to the bracket, tighten it with screws,
gently lid the RFID reader cover at last.
Note: Opening the lid of the battery compartment will trigger tamper switch,
please disarm the alarm by following the disarm instruction in page 21~22.
EN
8