iGPSPORT iGS630S Manual Del Usuario página 11

2）Select the device you want to delete, click Unpair and
press to confirm.
3）When deletion completed, the Bluetooth Disconnected
icon will display on the device.
Note：
Do not Pair and Unpair frequently.
FIRMWARE.UPDATE
To keep the device's best performance, please update its
firmware timely when a new version is available. Firmware
update can improve the user experience, including new
functions, the improvement of existing functions or error
repair. No data will be lost due to the firmware update.
Note:
・ Before the update, please make sure that the activity
data has synced to iGPSPORT account to avoid data loss. At
the same time, ensure that the computer is fully charged,
and the bluetooth and data network are stable.
・ Go to the iGPSPORT APP > Device > Firmware Update.
You can check if there is a new version available and
guidance on how to update.
・ The time needed depends on the strength of Bluetooth
signal. It takes up to 20 minutes, please wait patiently.
INSTALLATION.OF.STANDARD.BIKE.MOUNT
Use the included rubber bands to attach the standard bike
mount to the bike stem.
1）Place the rubber disk on the back of the standard bike
mount.
2）Select a suitable position on the bike stem to place the
rubber disk and the standard bike mount.
3）Use two rubber bands to bypass the bike stem
respectively, hook the buckle of the bike mount and fix it on
the bike stem.
4）Align the tabs on the back of the device with the
20
standard bike mount notches.
5）Place the cycling computer on the base and rotate it 90
degrees.
INSTALLING.THE.FRONT.EXTENSION.
BRACKET
1)Choose an appropriate mounting position on the
handlebar to avoid compromising riding safety.
2)Use a hex wrench to remove the screw ① from the
handlebar connector ② .
3) Wrap the handlebar with the rubber buffer and tighten
the screws (regularly check the tightness of the screws to
ensure safe use).
4) Align the base of the code counter with the mounting
slot ③ of the extension bracket and turn 90° clockwise until
the device locks.
Note:
・ You can also use the out-front bike mount (iGPSPORT
M80) to install cycling computer.
・ It is recommended that you use the official standard
bike mount or out-front bike mount of iGPSPORT to avoid
damaging the buckle of cycling computer.
GOING.FOR.A.RIDE
PRE-RIDING
To ensure the accurate riding data, you need to wait for the
device to detect the GPS signal before riding.
If the GPS signal is needed, please go outside and keep
21