iGPSPORT iGS630S Manual Del Usuario página 12

away from tall buildings and trees. Keep the device still and
the screen up, and avoid touching it when searching for GPS
signal.
If the sensor has been connected to the device before,
it will automatically connect to the device once waken up,
and the device will also automatically search for the sensor.
During your riding, the device will automatically measure your
heart rate, cadence and power and other data by using your
sensors.
When the satellites for locating is four (minimum), the GPS
icon shows , and you can start riding at this time. For
more accurate data, please wait until
icon becomes when enough satellites are found to ensure
good GPS Gaccuracy.
After all signals are detected, press
data page.
Press to start recording an activity on riding data page.
Press to start a new lap record, and the lap data will
display for 10 seconds.
Press or to exit the popup of the lap data.
During the riding data timing, press
Press to view the menu, select."Save"and press
again to save the recording.
After the successful save, the Riding Data Summary will
display.
Press / to select and view the riding data summary.
Press or o close the lap data popup.
WHILE-RIDING
Scan.Data.View
During the training, you can use
riding view. Please note, the displayable riding data view
and information depend on the selected cycling mode and
your modification to the selected mode.
22
or shows. GPS
to enter the cycling
to stop the timer.
or to switch
You can set up specific pages for different cycling modes on
the device and in the iGPSPORT APP. You can create custom
data fields for each activity mode and select the data you want
to see during the riding.
For more information, please see the activity content in
Cycling Mode.
Status.Page.View
During the riding, you can press
page. The information will display on Status page, including
sensors, weather and smart notifications.
Shortcut.Menu
During the riding, you can press
and you can access the functions such as page template, data
fields and elevation calibration from it.
・ Data Field Setting
Jump to template and fields selection setting of the current
page. See Cycling Mode > Page Setting, for details.
・ Cycling Mode Settings
Jump to current cycling mode page to quickly set up for it.
See Cycling Mode for details.
・ Elevation Calibration
Jump to Elevation Setting to set up the current elevation.
About Elevation: the built-in barometer covers the
calculation of elevation, ascent and descent. The barometer
can measure the elevation by converting the measured
air pressure into elevation reading. Ascent and descent are
displayed in meters/feet.
In the first several minutes of the riding, the air
pressure will be calibrated automatically via GPS. When
riding starts, the elevation calibration is only based on the
barometer, but the air pressure may not be accurate in
some conditions. Elevation will be corrected after calibration,
so any inaccurate reading before riding will be corrected
automatically later. After the riding finished and the data is
to view the Status
to open the menu
23