iGPSPORT iGS630S Manual Del Usuario página 19

SMART.NOTIFICATIONS
You can view the calls and messages notifications on the
device from the device, and you can set up options of smart
notifications through the iGPSPORT APP.
The notifications of calls and messages and from Apps
you received on the device are synchronized in real time with
those on your smartphone.
When receiving a notification, the device will notify you
with a popup at the bottom of the screen.
When a call comes in, the device will display the caller.
The smartphone notification is applicable to iOS and
Android. To enable this function, the iGPSPORT APP needs to
be installed on your smartphone to connect to the device. For
more details, please see Pairing Your Smartphone.
Please note, if the smartphone notification is enabled, the
battery consumption of the device and smartphone will be
faster because Bluetooth is continuously turned on.
SETTINGS
Press on the home page to view its options.
SENSORS
iGS630 can pair with sensors supporting ANT+ and
Bluetooth Protocol, including heart rate monitors, cadence
sensors, speed sensors, power meters, smart Trainers and
36
shifting. The specific third-party sensors that are compatible
with the device subject to the actual connection status.
Sensors.Pairing
Be sure that the sensor (heart rate monitor, cadence sensor,
speed sensor or third-party power meter) has been installed
correctly before the pairing. For more information about the
installation, please see its User Manual. It is recommended
that the ID of each sender should be checked to find the right
one in the list.
1）Go to Setting > Sensor > Add a Sensor, and press
Confirm on the device. Search for all sensors, possible search
for different types of sensors.
2）The device searches for sensors.
・ Cadence sensor： rotate the crank arms to wake up
the sensor. A flashing red light indicates that the sensor is
enabled.
・ Speed sensor： rotate the wheel to wake up the sensor.
A flashing red light indicates that the sensor is enabled.
・ Third-party power meter： rotate the crank arms to
wake up the sender.
3）When the sensor is found, the model number and ID
will be displayed. Select the sensor to connect and press to
start pairing.
4）After the successful pairing, the sensor will be in the
sensor list.
Note:
Please make sure that the sensor is waken up before
pairing.The sensor will automatically connect to the device if
it has been successfully paired with it.
Sensors.Setting
The sensor needs to be set to ensure its correct use and
accurate measurement of the sensor. The setting method is
as follows: select a connected sensor, press
menu and select the data to set.
to open the
37