Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
the filters will prolong the life of the appliance and keep it in good working order. Follow
the instructions below.
-
Cleaning method 1: Immerse the mesh filters in hot water (40-50 °C), add neutral
detergent and let them soak for 2 to 3 minutes. Protect yourself with gloves and clean the
filters with a soft brush or scouring pad. Do not apply too much force, as filters are very
delicate and can be easily damaged.
-
Cleaning method 2: If you wish, you can also wash the filters in the dishwasher at a
temperature of approx. 60 °C.
To remove the filter, press on the tabs as shown in Figure 12 and pull it out.
Always switch off the power supply before cleaning or performing any maintenance work on
the kitchen hood.
-
To prevent the outer surface of the kitchen hood from deteriorating over time, it is
recommended that it be cleaned with hot water and a neutral (non-corrosive) detergent
approximately every two months.
-
Do not use abrasive detergents. Otherwise, the surface of the kitchen hood may be
damaged.
-
Keep the motor and other parts away from water, as water may damage the appliance.
Replacing the light bulb/lamp
Please note:
-
The light bulb must be replaced by the official Cecotec Technical Support Service or
similarly qualified technicians.
-
Always disconnect the power supply before performing any operation on the appliance.
When handling the bulb, make sure that it has cooled down completely before any direct
contact with your hands.
-
When handling the bulbs, hold them with a cloth or gloves to prevent sweat from coming
into contact with the bulb, as this may reduce the bulb life.
Note:
-
Before changing the light bulb, make sure that the appliance is switched off and unplugged.
-
Protect yourself from danger when changing the light bulb, e.g., by wearing gloves.
-
Technical data of the light bulb/lamp: 220 V AC – 1*1.5 W
58
Bolero Flux CM 602200 White B / Black B / Inox B
6. TROUBLESHOOTING
Fault
Cause
The kitchen hood is switched off.
The light is on, but the motor
The kitchen hood is obstructed.
does not work
The condenser is damaged.
Motor is jammed or bearing
damaged.
Motor is burnt or gives off a bad
smell.
In addition to the above, check the following:
Neither the light bulb nor the
motor works
Fuse has blown or circuit breaker
has been tripped.
The light bulb has blown.
Power cable is loose or
disconnected.
Grease falls out of the mesh
The filters are very dirty.
filters
ENGLISH
Solution
Select a speed
using the buttons.
Contact the official
Cecotec Technical
Support Service.
Contact the official
Cecotec Technical
Support Service.
Contact the official
Cecotec Technical
Support Service.
Contact the official
Cecotec Technical
Support Service.
Replace the fuse
or reset the circuit
breaker in the main
switchboard of your
home. Remove any
other appliances
sharing the same
circuit with the
kitchen hood.
The light bulb must
be replaced.
The cable must
be connected
correctly.
Clean or replace the
filters immediately.
Bolero Flux CM 602200 White B / Black B / Inox B
59
Publicidad
