Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE USING THE CHOP SAW, IT IS CRITICAL
THAT YOU READ AND UNDERSTAND
THESE
SAFETY RULES.
I_,
WARNING
I
TO AVOID MISTAKES THAT COULD CAUSE SERIOUS
OR PERMANENT
INJURY, DO NOT PLUG IN THE
CHOP SAW UNTIL THE FOLLOWING INSTRUCTIONS
HAVE BEEN READ AND UNDERSTOOD.
1.
Learn to use the function of the ON/OFF switch,
cutting handle and wheel guard.
2.
Review and understand all safety instructions and
operating procedures in this operator's manual.
3.
Review the maintenance methods for this chop saw.
4.
Find and read all the warning labels found on the
chop saw:
• Read manual before using the chop saw.
• Wear safety goggles.
• Never perform cutting operations with wheel
guard removed.
• Turn power OFF, wait for abrasive wheel to stop
and remove power cord from power source before
adjusting or servicing.
5. The arbor bolt and all clamps have to be tightened
before cutting.
6.
Make sure the workpiece and the abrasive wheel do
not contact before operating the chop saw.
WHEN INSTALLING OR MOVING YOUR CHOP SAW:
I.
AVOID A DANGEROUS
ENVIRONMENT:
• Use the chop saw in a dry, indoor location
protected from rain and moisture.
• Keep work area well-lit.
.
TO AVOID INJURY FROM UNEXPECTED
CHOP
SAW MOVEMENT:
• Bolt or clamp the chop saw to a firm level surface
where there is plenty of room to move the
workpiece through the entire cut.
•
Position the chop saw so the feet are level and
the chop saw does not rock.
•
Position the chop saw where operators and
bystanders stand a safe distance away from the
saw and are not in direct line with the saw blade.
• To avoid injury from electrical shock, make sure
your fingers do not touch the plug's metal prongs
when plugging in or unplugging the chop saw.
• Turn OFF and unplug the chop saw before
moving it to a new area. To avoid back injury, get
help when transporting.
• Bolt the chop saw to the floor if it tends to move
when cutting long, heavy workpieces.
• DO NOT STAND ON the chop saw. Do not store
materials above or near it. Standing on the tool
could result in serious injury.
BEFORE EACH USE
1.
INSPECT YOUR CHOP SAW:
• If any part is missing, bent or broken in any way,
or any electrical part does not work properly, turn
the chop saw OFF and unplug the tool.
• Replace damaged or missing parts before using
the chop saw.
.
AVOID INJURY FROM JAMS, SLIPS OR
THROWN PIECES (KICKBACKS):
• Use this chop saw to cut ferrous material only.
• Avoid injury from thrown pieces. Make sure the
abrasive wheel is properly installed and the
arbor bolt is tight.
• Use the right tool. Do not force the tool to do a
job it is not intended to do.
.
INSPECT YOUR WORK AREA:
• Keep the work area clean.
• Cluttered areas and benches invite accidents.
The floor must not be slippery from wax or
sawdust.
• Avoid burns or other fire damage. Do not use the
chop saw near flammable liquids, vapours or
gases.
• Before using the chop saw, clear the table of all
objects not needed to feed the workpiece.
• Avoid injury. Do not perform layout, assembly, or
setup work on the chop saw.
• Never hold a workpiece. Workpiece will become
very hot while being cut.
4.
PLAN YOUR WORK:
• Before trying a new or not often used operation,
carefully plan your hand placement. Make sure
you have proper fixtures, stops, and other items
ready to use. Avoid injury form unsafe
accessories. Use only recommended
accessories.
r
_-
'.........
_
4
Publicidad
