Display Panel Indications; Ups Status Indicators - Riello Dialog Dual Serie Manual De Usuario

D P
ISPLAY ANEL
This chapter will describe in depth all the items of information that may be posted on the LCD.
For easier understanding, we can divide the information displayed into three main groups:

UPS status indicators

Measurements display area
Configuration area
UPS status indicators
ICON
I
NDICATIONS
STATUS
Fixed
Blinking
Fixed
Fixed
The UPS working on mains power, but the output voltage is not
Blinking
The UPS is working on battery power. When in this condition, the UPS
Fixed
End of discharge early warning. Indicates that the battery's back-up is
Blinking running out. In this condition, the UPS emits a beep at 1-second regular
Indicates that the loads connected to the UPS are being powered by the
Fixed
Dynamic
Indicates the % load applied to the UPS with respect to the nominal
Dynamic
Blinking
Indicates that the timer is activated (programmed switch-on or switch-
Fixed off). The timer can be activated/de-activated through the software
1 minute to go before the UPS is switched on again or 3 minutes until it
Blinking
DESCRIPTION
Indicates presence if a problem
The UPS is in stand-by mode
Indicates UPS operating normally
The UPS is working on mains power
synchronized with the mains voltage
emits a beep at 4-second regular intervals.
intervals.
bypass
Indicates the estimated percentage back-up
value
Maintenance action is needed
supplied
is switched off
U
SE
51