Lenco Classic Phono TCD-2551 Manual De Usuario página 13

⚫ Press POWER to turn the system on.
⚫ Press the PHONO button to enter the PHONO mode.
⚫ Make sure you have removed the stylus cover from the stylus and have released the
tone arm lock that secured the tone arm to the tone arm rest.
⚫ Set the turntable speed selector to appropriate speed 33, 45 or 78rpm. If you are
playing 45 rpm singles, place the 45rpm adapter on the centre spindle.
⚫ Place your record on the remove centre spindle.
⚫ Raise the TONEARM LIFT to lift the tone arm of its rest. Move the tone arm to the edge
of the record. The turntable starts automatically. Use the TONEARM LIFT to gently
lower the tone arm onto the record.
⚫ Adjust the volume control to the desired level.
⚫ When the tone arm reaches the end of the record it automatically stops the record.
⚫ Press POWER again to turn the system off.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction "B".
2. Push the stylus upward as in direction "C" until the stylus locks into the tip position.
NOTES
We advise you to clean your records with an anti-static cloth to gain maximum enjoyment from
them.
We would also point out that for the same reason your stylus should be replaced periodically
(approximately every 250 playback hours)
BLUETOOTH PLAY
Press the CD/USB/BT multiple times until the display shows 'BT'.
Search for 'Lenco TCD-2551' on your transmitting device and select it to pair. When the connection
is successful a beep will play and the display stops blinking.
AUX IN OPERATION
Connect the audio system into the AUX IN jack on the front panel, Press the TAPE/AUX button
twice. Start playing from the connected device.
Guide Pins (inside)
13