CASO DESIGN Selection WK 2200 Manual Del Usuario página 33

14.3 Rating plate
The rating plate with the connection and performance data can be found beneath the
device.
15 Operation and Handling
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages.
► Do not leave the appliance unsupervised during operation.
15.1 Before first use
Fill the device with water up to the maximum water level. Boil the water and let the device
cool down. Discard the water. Repeat this 2x.
► Do not fill the pot over maximum level as water may spout out of device when boiling.
Make sure the lid is firmly closed before you place it on the base again.
► Do not fill the device below the minimum mark, otherwise the device will run dry and
the overheating protection will switch on.
► To select between °C and °F, press and hold the
► If you lift the jug during the cooking process, the cooking process or the keep-warm
process stops.
15.2 Quickstart 100 °C
To boil water directly at 100 °C, fill the jug with water and press the
boiling process starts immediately. You can stop the boiling process at any time by
pressing the
15.3 Use
Lift the pot from the base and open the lid. Fill water into the pot.
Then place the device back on the base and insert the power plug into a suitable socket.
The display lights up. After 3 minutes without action, the unit automatically switches to
standby mode.
Press any button to reactivate the display.
Set the desired temperature with the
To start the cooking process, press the
Warning
Please note
- button.
button for a moment.
/ - buttons.
- button. The
- button. The
- symbol lights up.
33