Publicidad
Idiomas disponibles
Idiomas disponibles
FCC instruction
Responsible party Sensio Inc . New York, NY 10016/USA 1-866-832-4843
17828,17831,17832_BellaxSoYummy_Target_Portable Blender_V4_R3_IM.indd 4
17828,17831,17832_BellaxSoYummy_Target_Portable Blender_V4_R3_IM.indd 4
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation .
The users manual or instruction manual for an intentional or
unintentional radiator shall caution the user that changes or
modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the
equipment . In cases where the manual is provided only in a form
other than paper, such as on a computer disk or over the Internet, the
information required by this section may be included in the manual in
that alternative form, provided the user can reasonably be expected
to have the capability to access information in that form .
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules .
These limits are designed to provide reasonable protection against
harmful interference in a residential installation . This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications . However, there is no
guarantee that interference will not occur in a particular installation . If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna .
Increase the separation between the equipment and receiver .
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected .
Consult the dealer or an experienced radio/TV technician for help .
4
2023-10-20 9:49 AM
2023-10-20 9:49 AM
Publicidad
