Proxxon PF 230 Instrucciones De Servicio página 7

Setting compound-type table guide play
If, after a time, the compound-type table guide is found to
have too much or too little play, the play can be reset using
the adjusting screws 2 (Fig. 15). For this purpose, loosen
adjustment screw lock nuts 1 and screw in all adjustment
screws evenly until play is eliminated. Retighten lock nuts
afterwards.
Setting compound-type table spindle play
If play of the spindles increases, release the nut 1 using a
socket spanner 2 (Fig. 16) approx. one half turn until play is
eliminated. Then turn the hand wheel to the right hand
direction until the play has been eliminated. Now retighten
the nut 1 firmly (lock).
See exploded view, page 48 Where necessary, play in the
individual spindle threads can also be achieved by slightly
tightening the spindle nut, Item 3, with the bolt, Item 25.
Machine lubrication
To ensure a long service life of your machine, please
observe the lubrication diagram in Fig. 17 (A: Lubricate
each time before use / B: Lubricate once a month). Only
use acid-free machine oil for lubrication.
After use
Important!
Disconnect milling machine mains plug before cleaning.
Risk of injury!
Clean compound-type table and milling machine using a
soft cloth and brush after use. Then lightly oil the guides
and distribute the oil by moving the table. Never use
compressed air for cleaning the compound-type table as
cuttings entering the guides in this manner could destroy
the guides.
Note:
EC Declaration of Conformity
We assume sole liability for ensuring that this product
conforms with the following EC guidelines:
• EC Low Voltage Guideline 73/23 EEC; 93/68 EEC
• DIN EN 61029 / 02.2001
• EC Machine Guideline 98/037 EEC
• DIN EN 61029 / 02.2001
• EC-EMC Guideline 89/336/EEC
• DIN EN 55014-1 / 09.2002
• DIN EN 55014-2 / 08.2002
• DIN EN 61000-3-2 / 12.2001
• DIN EN 61000-3-3 / 2002
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Equipment Safety Division
- 11 -