ST MH 500 Li 48 Manual De Instrucciones página 145

PROBLEM
7. The cutting means comes into
contact with a foreign body.
8. Excessive noise and/or
vibration is experienced
whilst working
9. The machine gives off
smoke whilst working
10. Battery power reserve is low
11. The battery charger is not
recharging the battery
If problems persist after having performed the above operations, contact your dealer.
15. ATTACHMENTS ON REQUEST
15.1 BATTERY
Different capacity batteries are available to
suit specific operating requirements (Fig.20).
The list of approved batteries for this machine
is found in the "Technical Data" table.
15.2 BATTERY CHARGER
Device used to recharge the battery: fast
(Fig. 21.A), standard (Fig. 21.B).
PROBABLE CAUSE
-
Loose or damaged parts
Machine damaged.
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Battery is not correctly inserted
in the battery charger
Unsuitable environmental
conditions
Dirty contacts
The battery charger
is not energised
Faulty battery charger
EN - 15
Turn off the machine, remove the battery and:
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Turn off the machine, remove the battery and:
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Do not use the machine. Immediately turn
off the machine, remove the battery and
Contact an Authorised Service Centre.
Optimise operations
(par. 7.2.1)
Use a second battery or extended
battery (par. 15.1)
Purchase a new battery
Check it is correctly inserted (par. 7.2.3)
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the
battery/battery charger manual
15.3 BATTERY BACKPACK
Device which allows the housing of
two batteries and provides the power
needed to operate the machine.
It is equipped with the cable to connect to
the machine (Fig. 1.L) and a selector switch
(Fig. 7.B) which allows you to select one of the
two batteries ( position "1" and "2") and "OFF".
15.4 BATTERY SIMULATOR
Device that, if inserted in the machine housing,
allows the use of the battery backpack.
SOLUTION