Kenmore 596.7931 Manual De Uso Y Cuidado página 13

Wait 24 hours for your refrigerator to cool completely before adding
food. If you add food before the refrigerator has cooled completely,
your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature controls to a
colder than recommended setting will not cool the compartments any
faster.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not blocked before
adjusting the controls.
To Turn Off/On:
Press both Minus Sign touch pads repeatedly until a dash (-) appears in
both the refrigerator and freezer displays. Neither compartment will cool.
Humidity Control (on some models)
The humidity control turns on a heater to help reduce moisture on the door
hinge seal. Use in humid environments or when you notice moisture on the
door hinge seal. The refrigerator uses more energy when Humidity Control
iS on.
• Press the control to ON when the environment is warm and more
humid, or if you notice moisture on the door hinge seal.
• Press the control to OFF to save energy when the environment is less
humid.
HumidityControl
On Off
Adjusting Controls
If you need to adjust the temperature in either the refrigerator or freezer
compartment, use the settings listed in the chart below as a guide.
Press the up or down arrow touch pads to adjust the temperature. Except
when starting the refrigerator, do not adjust either control more than one
setting at a time. Wait 24 hours between adjustments for the temperature
to stabilize.
CONDITION/REASON= ADJUSTMENT=
REFRIGERATOR too warm REFRIGERATOR Control
one setting higher
FREEZER too warm/too little ice FREEZER Control one setting
higher
REFRIGERATOR too cold REFRIGERATOR Control
one setting lower
FREEZER too cold FREEZER Control one setting
lower
_i:e 9e_x:_x_,She_ves
The shelves in your refrigerator are adjustable to meet your individual
storage needs.
Storing similar food items together in your refrigerator and adjusting the
shelves to fit different heights of items will make finding the exact item you
want easier. It will also reduce the amount of time the refrigerator door is
open, and save energy.
Shelves and Shelf Frames
To remove and replace a shelf/shelf frame:
1. Remove the shelf/frame by tilting it up at the front and lifting it out of
the shelf supports.
2. Replace the shelf/frame by guiding the rear shelf hooks into the shelf
supports. Tilt the front of the shelf up until rear shelf hooks drop into
the shelf supports.
3. Lower the front of the shelf and make sure that the shelf is in position.
4
To remove and replace the crisper(s):
1. Slide crisper(s) straight out to the stop. Lift the front of the crisper(s)
and slide out the rest of the way.
2. Replace the crisper(s) by sliding back in fully past the drawer stop.
To remove the crisper(s) cover:
1. Remove crisper(s).
2. Holding the glass insert firmly with one hand, press up in center of
glass insert until it rises above the plastic frame. Gently slide the glass
insert forward to remove.
3. Lift the cover frame up and remove it.
REFRIGERATOR FEATURES
Your model may have some or all of these features.
important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
To replace crisper(s) cover.-
1. Fit back of cover frame into supports on side walls of the refrigerator
and lower the front of the cover frame into place.
2. Slide rear of glass insert into cover frame and lower front into place.
13