Publicidad
Idiomas disponibles
Idiomas disponibles
– Push the left and right tensioning bolts -13- towards the vehi-
cle centre -arrow A- to loosen pin link -5- from the holes in
the roof rail -arrow B-.
– Unhook the claw fasteners -10- on both sides -arrow C- and
carefully remove the carrier unit.
– Screw in the tensioning bolts -13- by approx. 12 rotations
and close the cover flap -12-.
4.4
Maintenance instructions
Carrier units
The carrier units must always be cleaned and kept in good or-
der. It is particularly important to remove any dirt and salt in the
winter.
The carrier units can be cleaned using water.
Locks
The locks must be maintained after several locking cycles have
passed, and always after wet cleaning has been performed.
This process involves spraying the dust/dirt guard and the in-
side of the cylinder with an appropriate lubricant and then ac-
tuating the lock several times using the key.
WARNING
Do not use any lubricants on the bolted connections.
Failure to comply with these instructions may result in
the carrier units becoming detached, causing injury to
you or others and/or damage to property.
Caution
Do not use a high-pressure cleaner to clean the kayak hold-
ers.
4.5
Technical notes
Technical data
Dead weight of carrier unit set: approx. 5 kg (11 lbs.).
Roof load/load
To determine the roof load:
Weight of the carrier unit
+
weight of the roof rack module
+
weight of the load
=
roof load
Installation instructions - Audi A4 (8W) Avant 2016 ►
4 Installing/removing the carrier units
Edition 07.2015
13
Publicidad
