Costway OP70337 Manual De Instrucciones página 5

9.Keep the blower(air pump) and power cord away from water and
moisture.If water contacts the blower(air pump), unplug the
blower(air pump) power cord. Do not operate until the blower is
completely dry.
10.Ensure the blower(air pump) is free from debris and securely
sited to avoid tripping. To inflate the bouncer unit,(press the reset
button on GFCI) turn the blower (air pump) "on/off" switch to on. The
continual air-flow blower (air pump) must be left on at all times while
the Bouncer is being used. (Refer to picture 2)
11.If the product comes with water bags, please follow the
undermentioned instruction, otherwise, overleap this point. Spread
out the product, place and fasten the empty water bags at the two
sides of the product. Open the stopple and fill water in the water
bags until 80% full (about 22kg), push and close the stopple.Make
sure water bags are firmly attached on the product and no water
leakage before the product is fully inflated, and never allow children
to play on the side without installing water bags. (Refer to picture 3)
12.The Bouncer should take less than 2 minutes to inflate.
13.If the product comes with slide extension, please follow the
undermentioned instruction, otherwise, overleap this point. Add the
slide extension to the end of the slide using the hook and loop
fastener fastener. (Refer to picture 4)
14.Ground support stakes are used for lawn ground surfaces.Hook
stakes over loops in the Bouncer. To prevent overturn or lift during
play, push stakes firmly into the soil. The stakes should be placed
level with or under the ground in order to reduce tripping hazards.
(Refer to picture 5)
15.To prevent overturning during play, periodically check that the
ground stakes are securely in place. To anchor the product
properly,ALWAYS anchor the product and blower with corresponding
ground stakes before use.
08
16.Make sure the Bouncer is inflated fully and securely anchored
before children enter to play.
17.Failure to do so will result in the product being unstable and can
cause serious injuries. Use of this product when under-inflated or
during deflation could cause serious injuries.
18.Always check for excessive air loss, and re-inflate before
allowing play to continue. As the product remains inflated through
constant air flow, air leakage from the seams is normal and
necessary so the product does not over inflate.
Disassembly Instructions
1.Make sure all children exit the Bouncer.
2.Make sure the Bouncer is free of foreign abjects.
3.Turn the blower (air pump) "on/off" switch to off.
4.Unplug the blower (air pump) power cord.
5.Loosen string and detach the air fill tube from the blower.
6.Remove ground support stakes and plastic balls.
7.Let the Bouncer deflate entirely. It should deflate on its own within
5 minutes. (Refer to picture A)
8.Fold it in half, and then fold it in half 2 more times, parallel to the
first fold. (Refer to picture B and C)
9.Roll it up tightly from the end opposite the air fill tube.(Refer to
picture D and E)
10.Slip carry bag over the rolled-up Bouncer and plastic balls.(Refer
to picture F)
11.Flip the bag and the Bouncer over, close the bag zipper. (Refer to
picture G)
12.Store the Bouncer and the Blower in a dry place for future use.
13.Never leave either the Bouncer or the Blower outside in the rain
when product is not in use.
09