Husqvarna EPOS RS1 Manual De Usuario página 16

To install objects on the map, operate the product with
the appDrive installation to add waypoints on the map.
To install objects on the map on page 16 .
Refer to
3.10.6.1 To install objects on the map
The waypoints (A) are positions that makes the virtual
boundaries and paths (B). The lines are straight
between the waypoints. It is recommended to use as
few waypoints as possible. For each work area and
the related stay-out zones and transport path the total
maximum number of waypoints are 800. Husqvarna
recommends to add maximum 1000 waypoints for the
complete installation of the map. You can adjust the
positions of the waypoints in the app after the installation
of the map. To make smooth curves use several
waypoints. Husqvarna recommends to set the minimum
distance of 30 cm / 1 ft. between the waypoints. You can
adjust the positions of the waypoints in the app after the
installation of the map.
A
CAUTION:
Do not lift and move the
product between the waypoints when you
install the map objects. Use appDrive for a
correct installation.
Note:
The position of the waypoint when you install a
work area or a stay-out zone is in the front left corner
of the product. The work area is specified by the virtual
boundaries. The product cannot cut all the grass in the
work area because of the position of the cutting disc.
16 - Installation
Note:
transport path or a path to a maintenance point is in the
middle of the product between the drive wheels.
•
•
B
•
•
•
•
•
•
•
•
The position of the waypoint when you install a
Make sure that you are near the product and
connected to the product with the app with
Bluetooth ® .
EPOS
Make sure that the status is
the appDrive.
Note:
A game controller with Bluetooth
be used together with appDrive to operate the
product.
Select the object you want to install and use the
buttons in the appDrive installation to operate the
product.
Use the up button (A) to move the product forward.
Use the down button (B) to move the product
rearward.
Use the left arrow button (C) to rotate the product
to the left.
Use the right arrow button (D) to rotate the product
to the right.
Use the center button (E) as a joystick to move and
rotate the product in any direction.
Use the waypoint button (F) to add a waypoint in
the map.
Use the undo button (G) to remove the latest
waypoint.
A
E
C
D
B
2211 - 002 - 30.11.2023
™ confirmed in
®
can
G
F