ProBreeze PB-06 Manual De Instrucciones página 6

Note: If no specific settings are selected the dehumidifier will run in AUTO mode.
Setting a Turn-Off timer:
1. Press the Power button to turn the dehumidifier on.
2. Set the dehumidifier to the desired settings.
3. Press the Timer button to activate the timer function.
Press Timer button to set the desired time (1-24 hours).
4.
5. The time digits will blink five times to confirm a timer has been set and then
revert to the current room humidity.
6. To check the remaining time until Time-Off press the Timer button.
SLEEP Mode: Press the SLEEP mode / STORAGE Cycle Button to activate. In
SLEEP mode the dehumidifiers humidity is set to 50% and the fan operates in low
speed. If the actual room humidity is 5% greater than 50% humidity the
dehumidifiers compressor will activate, and the fan will operate at low speed. If the
actual room humidity is 5% less than 50% humidity the dehumidifiers compressor
will stop collecting water but the fan will continue to operate at low speed.
Note: Fan speed cannot be adjusted when SLEEP mode is set.
STORAGE Cycle: Press and hold the SLEEP mode / STORAGE Cycle button for
three seconds to activate. The dehumidifiers compressor stops collecting water, and
the fan runs at high speed for 30 minutes followed by a further 20 minutes at low
speed. This process dries the dehumidifier prior to storage.
Note: Prior to storage ALWAYS run a STORAGE cycle.
Fan Speed Button: Sets the fan speed to HIGH or LOW speed.
Humidity Button: Sets your desired humidity level between 80% - 30% humidity in
5% decrements.
5 | English