Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
REMOTE CONTROL
UNIT
@
Inserting the dry cel! batteries
batteries.
e
The batteries will need to be replaced approximately
once
a year. This will depend
upon
how
often the
remote
control
unit is used.
e
if, in less than a year from the time new batteries were
inserted, the remote
control fails to operate this unit
from
a near-by
position,
it is time to replace
the
batteries.
e
Insert the batteries properly, following the diagram on
the remote control battery supply unit, and making sure
to align the plus and
minus
sides of each
battery.
e
Batteries are prone to damage and leakage. Therefore:
e
Do not combine
new
batteries with
used
ones.
e
Do not combine
different types of batteries.
e
Do not jumper the opposite poles of the batteries,
expose them to heat or break them open, or put
them
into open
fire.
e@ When the remote control unit is not to be used for a long
period of time, remove
the batteries from
the unit.
e
If the batteries have leaked, remove any battery fluid
from the inside of the battery supply unit by wiping it
out thoroughly,
and
insert new
batteries.
2 Insert two size RO3 ("AAA") dry cell batteries as shown
in the diagram
on the battery supply
unit.
@ Using the remote contro! unit
POWER button
Tuning
Press to set the tuner
buttons
power to on or standby.
Use these to increase
or
decrease
the reception
frequency.
Band select
Preset scan button
Tuning ep ee
|
seconds.
v presetcH alf
Scanning
stops when
the
button
button is pressed again,
and the current
station
is received.
sensor on the tuner when
pressing buttons.
e@ The remote control unit can be used at a distance of about 8
meters directly in front of the tuner.
The remote control unit uses infrared rays, so it will not work if
there are obstacles between it and the tuner. Also, if used at an
angle, the distance from which operation is possible will be
shortened.
e
Do not press buttons on the tuner and the remote control unit
simultaneously, as this may result in malfunction.
e
The remote control unit may not function if intense light is
shining on the tuner's remote control sensor.
©
Do not operate two remote control units simultaneously, as
this may result in malfunction.
Preset channel
DENON
REMOTE CONTROL UNIT
acizs | Duttons
Use these to move
up
and down among the
preset channels.
Publicidad
