Descargar Imprimir esta página

VEVOR LB100T Manual De Instrucciones página 16

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 90
clean it, firstly open the front cover, take out the spray pipe, and then scour
off the scum till the every hole is unblocked. Reinstalled it after finish
cleaning.
C、After finishing washing,screw out the cap of the drain-valve and drain
out all the dirty water, then tighten the cap。
4. Automatically cleaning of the ice maker
Automatically cleaning of the ice maker: when the machine is making ice,
softly push the "clean" key on the electrical box which is on the rear panel,
the refrigeration system will stop work, and the machine turn into
auto-wash process. The total wash processes is divided into three steps:
wash, potch and drain. It will cost bout 30 minutes. In order to improve
cleaning effect, the user can add a little neutral detergent, after finishing
washing, the machine turns into ice-make condition automatically.
A、Usually, the machine is connected to the power source continually.
When you connect the machine to the power source firstly, there is a clean
process after the water in sink is full: water supply——water pump works
——water pump works and drain-valve opens——water supply——water
pump works——water pump works and drain-valve opens——pressure
balances. This process will cost about 5 minutes(once every 30 ice-make
cycle). In addition, after every four ice-make cycles, there is a drain
process, drain out the water in the sink.
- 15 -

Publicidad

loading

Este manual también es adecuado para:

Lb160tLb200tLb265t