Publicidad
Idiomas disponibles
Idiomas disponibles
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don't
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.
Tools and Materials
Plumbers
Adjustable
Putty
Wrench
Before You Begin
Observe all local plumbing and building codes.
Shut off the main water supply.
Carefully inspect the waste and supply tubing for any sign of
damage.
For new installations, install the faucet and drain to the lavatory
before installing the lavatory.
Faucet body should be installed no more than 1-1/8" (2.9 cm)
from the lip of the lavatory rim for the sensor to work. The faucet
body thickness is 2-1/4" (5.7 cm) or 2-3/8" (6 cm) with base.
If not using the optional thermostatic mixing valve, note that the
faucet has a single 1/2" NPSM inlet for cold or tempered water.
If the water in your area contains high levels of particulates,
install a 20 micron water filter in the supply line.
This faucet contains an in-line strainer located near the bottom of
the faucet shank. Remove and clean this strainer if the faucet
experiences reduced water flow.
Kohler Co. reserves the right to make revisions in the design of
faucets without notice, as specified in the Price Book.
1031174-2-A
Plus:
• Power supply, K-13667
(required)
• Thermostatic Mixing Valve
Pliers
(optional)
• Shut-off Valves
• Supply Piping
2
Kohler Co.
Publicidad
