Publicidad
Idiomas disponibles
Idiomas disponibles
on
NOTE: Wait for 24 hours to turn on air conditioner
if the unit has been tilted for any
reason. This is for the oils and the coolants
to settle and level off.
1. After a normal shut down wait for 3 minutes
before restarting
the unit
so as to complete
the
compressor
cycle.
2. Use an 115v/15
amp outlet for the air conditioner.
Do not use any other electrical
appliances
on
this line or you may trip the fuse. Use a dedicated
line for this air conditioner.
3. Do not place the air conditioner
in direct sunlight
or close to any heating appliances
(eg. baseboard
heaters,
stoves, etc).
4. Operate
on a flat surface only.
5. Keep the unit free of any obstructions
such as drapes,
curtains,
blinds, etc.
6. Keep unit at least 1 foot away from the wall.
7. Check and clean the filter once every week for highest
efficiency.
NOTE: Do not use unit without
filter.
8. If the unit is not being used for a long period of time, remove the plug from the water drain pipe
and drain out any condensed
water.
When
turning
on the unit for the first
time
after
plugging
it into an electrical
outlet,
the unit will start
in a low fan cool
mode.
The temperature
reading
out on the
LED will be the current
room
tempera
ture.
When
turning
on the unit during
regular
usage,
it will remember
the last shut off setting.
If you
want
to operate
the air conditioner
as a dehumidifier,
then
adjust
to dehumidify
mode.
SETTING THE TEMPERATURE
To set the temperature,
press the + or the
key to raise or lower the temperature.
The temperature
can be raised or lowered
in the cool or dry mode. The temperature
cannot
be adjusted
in the fan
mode.
FAN SPEEDS
There are 3 adjustable
speeds
in the cool and fan mode: Low, Medium
& High_ In the dry or
dehumidification
mode the fan will only operate
at low speed.
ON/OFF
TIME SET
The air conditioner
has a 1 12
hour on!off
builtin
timer.
To delay
the start
time for 1 12
hours
at 1
hour
intervals,
simply
press
"Timer"
key (or On/OFF Timer
Key) to adjust
the start
time.
Note
that the
unit
has to be plugged
in to an electrical
outlet
for the timer
to operate.
To automatically
shutoff
the unit, press "Timer"
key while the unit is running to adjust the shutoff
time. The auto shutoff
switch operates
in all 3 modes: Cool, Dry & Fan.
NOTE: The
temperature
can
be set between
60°F to 89°E
Publicidad
