Descargar Imprimir esta página

Electrolux EFC226B Manual De Instrucciones página 52

Ocultar thumbs Ver también para EFC226B:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
1
2
2. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter -
optional
WARNING!
The charcoal filter is NON-washable! The
filter cannot be regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Turn the filter counterclockwise (1) and
then pull (2).
1
2
To mount the filters back follow the steps in
reverse order.
In any case, it is necessary to replace the
filters at least every four months.
6.4 Replacing the lamp
WARNING!
Risk of burns and electric shock!
Disconnect the appliance from the
electricity before the operation! Make
sure that the light bulb has cooled down
before touching it.
WARNING!
Risk of injury! Use protective gloves to
replace the lamp.
Risk of damage to the appliance! Do not
use sharp edged tools!
Replace the burnt light bulb in accordance
with the specifications:
Power (W)
Socket
Voltage (V)
Dimensions (mm)
ILCOS D Code (accord‐
ing IEC 61231)
To replace the lamp:
1. The lamp cover has two slots on each
side. Use a flat non sharp plastic tool.
Gently remove the lamp cover from the
appliance.
2. Replace the lamp.
3. Mount the lamp cover.
52
4
E14
220 - 240
37 x 100 (diameter x
length)
DRBB/F-4-220-240-
E14-37/100

Publicidad

loading

Este manual también es adecuado para:

Efc226cEfc226rEfc226v