Klarstein BRISA 10041402 Manual Del Usuario página 41

TROUBLESHOOTING
Problem
The light turns on but
the motor does not run.
The light is off and the
motor does not run.
The housing vibrates.
The air is not being
properly extracted.
NOTES ON ENVIRONMENTAL PROTECTION
• Make sure there is sufficient air supply during cooking so that the cooker
hood can work efficiently and with low operating noise.
• Adjust the fan speed to the amount of steam produced while cooking. Use the
intensive mode only when necessary. The lower the fan speed, the less energy
is consumed.
• If large amounts of steam are produced when cooking, select a higher fan
speed in time. If the cooking steam has already spread throughout the
kitchen, the cooker hood must be operated for longer.
• Switch off the cooker hood when it is no longer needed.
• Switch off the lighting when it is no longer needed.
• Clean the filter at regular intervals and replace it if necessary to increase the
effectiveness of the ventilation system and prevent fire hazards.
• Always put the lid on when cooking to reduce cooking steam and
condensation.
Potential cause
The rotor blade of the
fan is blocked.
The motor is broken.
The light is broken.
The plug is loose.
The rotor blade of the
fan is damaged.
The motor is not firmly
seated.
The casing is loosely
hanging.
The distance between
the cooker and the
extractor hood is too far.
Solution
Switch off the appliance
and have it repaired by
qualified personnel only.
Have the light replaced.
Plug the power plug
securely into the wall
socket.
Switch off the appliance
and have it repaired by
qualified personnel only.
Remove the appliance
and make sure that
the bracket is properly
attached.
Reduce the distance to
65-75 cm.
EN
41