Publicidad
Idiomas disponibles
Idiomas disponibles
2) Remove the blade and brush off
the cut hairs from the blade
edge.
3) Brush the cut hairs out from the
gap between the fixed blade
and the moving blade. Press
down on the lever for cleaning
in order to raise the moving
blade, and brush the cut hairs
out from the gap between the
blades. (Fig. 9)
4) Apply a few drops of the oil to
the points
indicated
by the
arrows in Fig. 10, 11.
5) Remount
the
blade
on
the
clipper body.
Special attention when
charging
e Avoid charging the battery at
temperatures
below
0°С
or
above 40°С.
e Avoid charging the battery in
direct sunlight or near a radiating
heat source.
Caution:
е Clean the housing using only a
cloth slightly dampened
with
water or a mild soap solution.
% Never use a caustic solution.
e Never submerge the hair clipper
in water.
e Keep out of the reach of children.
e Do not use to trim the hair of a pet.
e The hair clipper may become
warm
during operation and/or
charging. This is normal.
® Avoid grabbing the hair clipper
by the power cord, as it may
become detached, causing dam-
age or injury.
Ф Never tamper with moving parts.
e if the hair clipper is not working
properly, have it inspected at an
authorized service center.
e Use the ER145 hair clipper with
the RES5-69 adapter only.
Note:
The Supply cord of the charging
adaptor
ЯЕ5-69
cannot
be
replaced; if the cord damaged,the
appliance should is discarded.
ATTENTION:
A nickel cadmium
battery that is
recyclable powers the product you
have purchased.
|
At the end of its useful life, under
various state and local laws, it is
illegal to dispose of this battery into
your municipal waste stream.
Please call 1-800-8-BATTERY
for
information on how to recycle this
battery.
How to remove the built-in
rechargeable battery
before disposal
of the clipper
The battery in this clipper 18 not
intended to be replaced.
The procedure described below is
intended only for the purpose of
proper disposal. Discard the clipper
after
the
battery
has
been
removed.
Publicidad
