Descargar Imprimir esta página

Craftsman 316.791970 Manual De Instrucciones página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

OilFill
Plug
Spark
Muffler
Plug
Starter Rope
Grip
Line
Cutting
Blade
Craftsman®
Convertible
TM
Coupler
On/Off Stop
D-Handle
Control
Shaft Grip
Cold Weather
Start Lever
Throttle
Control
_l Cap
Shaft
Housing
Air Filter Cover
Primer Bulb
\
Trimmer
Attachment
Cutting Attachment
Shield
Hassle-Free
TM
Plus
!_
ARNING:
DO NOT ATTEMPT TO USE THIS UNIT
UNTIL THE D-HANDLE HAS BEEN ROTATED INTO
OPERATING POSITION (Fig. 1).
ADJUSTING
THE D-HANDLE
1.
Loosen the screws on the D-handle (Fig. 1).
On/Off Stop Control
Shaft
Housing
(4) Screws
Shaft Grip
Minimum 6
(15.24 crn)
D-Handle_
Fig. t
iNSTALL MNE TRIMMER
ATTACHMENT
NOTE:
To make installation easier,
place the unit on the ground or
on a workbench.
1.
Turn knob counterclockwise
to
loosen coupler (Fig. 16, p. 9).
2.
While firmly holding attachment,
push it straight into the coupler
until the release button snaps into
the primary hole (Fig. 17, p. 9).
NOTE:
Aligning the release button with
the guide recess (Fig. 17, p. 9)
will help installation.
3.
Turn the knob clockwise to tighten.
LiNE TRIMMER
APPMCATIONS
Cutting grass and light weeds; edging;
and decorative trimming around trees,
fences, etc.
Bottom
Clamp
Fig. 2
2.
While holding the unit in the operating position (Fig. 2), position
the D-handle to the location that provides you the best grip.
3.
Tighten the clamp screws evenly, until the D-handle is secure.

Publicidad

loading