Sony Trinitron PVM-1453MD Instrucciones De Uso página 11

Operating through Menus
There are five buttons for menu operations on the front
panel of the monitor. To display the main menu, first press
MENU (EXIT). The buttons you can use appear at the
bottom of the menu screen.
UNDER OVER
SCAN SCAN
RESET Buttons for
button menu
operations
MENU _ | return to the return to the previous
previous menu. menu.
ENTER _ | decide a selected
item.
SELECT
move the cursor (P) | increase selected
upwards. value.
GS | Move the cursor (>) | decrease selected
4 downwards. value.
i .SCté'<—~SS
reset current
RESET adjustment value to the
factory setting.
=i]
(The above items in white type correspond to the marks in
the menu.)
The Contents of Menu Items
The following sentences show the details of each menu
items.
[ ] indicates the factory setting position.
Main menu
Select an item and press the ENTER (SELECT) button
to go to the following menu.
[2] COLOR TEMP SELECT menu
Select the color temperature from among 6500K, 5600K
and USER. USER is set to 6500K in the factory setting.
You can adjust or change the color temperature in
USER mode (a measuring instrument is needed).
[6500K]
| Note |
The color temperature of the USER mode can be
adjusted in the range from 3200K to 10000K.
You can adjust the color temperature of the USER mode
in the USER COLOR TEMP ADJUST menu ([12]) of
the user service mode.
For the details, see USER COLOR TEMP ADJUST
menu ([12]) on page 12.
PRESET menu
You can preset each control to a desired level and set it.
If you set PRESET to ON, the REMOTE indicator
lights up and the controls on the front panel do not
work. The monitor operates with the internal memory
settings. For adjustment, select the PRESET ADJUST
screen.
[OFF]
[4] CONFIG menu
Select an item for adjustment of the monitor.
[5] PRESET ADJUST screen
Adjust CONTRAST, BRIGHT, CHROMA, PHASE,
VOLUME, APERTURE in the PRESET menu.
[6] CHROMA SET UP menu
Set to ON to adjust the internal decoder for CHROMA
and PHASE (NTSC signal only) after AUTO ADJUST
screen (11).
[OFF]
RGB A SYSTEM menu
To monitor the signal fed through the RGB/
COMPONENT A connectors, set the RGB or COMP
(component) signal and the INT SYNC (internal sync)
or EXT SYNC (external sync) signal in this menu.
{[RGB-INT SYNC]
RGB B SYSTEM menu
To monitor the signal fed through the RGB/
COMPONENT B connectors, set the RGB or COMP
(component) signal and the INT SYNC (internal sync)
or EXT SYNC (external sync) signal in this menu.
[RGB-INT SYNC]
11