Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
INSTALLING HANDLE
To install handle
1. Place handle in recess (3)
2. Insert provided screws (1)
3. Use Phillips screwdriver to secure and tighten.
INSTALLING CASTERS
Use provided casters and insert into the bottom of caster
base as shown in Figure (A). Strong pressure required
and listen for the click to ensure locked in place.
OPERATING INSTRUCTIONS
WARNING
To reduce the risk of fire or explosion, do not operate this vacuum in areas with flammable
gases, vapors or explosive dust in the air. Flammable gases or vapors include but are
not limited to: lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium,
aluminum, and grain or gun powder. Do not vacuum explosive dust, flammable or
combustible liquids or hot ashes. Do not use this vacuum as a sprayer for any flammable
or combustible liquid. To reduce the risk of health hazards from vapors or dusts, do
not vacuum toxic materials.
WARNING
The operation of any utility vacuum can result in foreign objects being blown into the eyes,
which can result in severe eye damage. Always wear safety eyewear complying with
ANSI Z87.1 (or in Canada, CSA Z94.3) before starting operation.
CAUTION
To reduce risk of hearing damage, wear ear protectors when using the vacuum for
extended hours or when using it in a noisy area.This 15.1 Liter / 4 Gal wet/dry vacuum
is assembled at the factory and ready for use when you remove it from the carton. The
unit is ready for dry vacuuming or blowing. After you plug the power cord into the wall
receptacle, turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the "OFF" position and the
"I" is the "ON" position.
(1)
(2)
(3)
O = OFF I = ON
6
(1)
(2)
(3)
Figure (A)
Publicidad
