Tenda IT Serie Guía De Instalación Rápida página 10

Log in to web UI
These series of cameras can be managed on the web UI.
1. Connect the computer to the switch or router that is connected to the camera.
2. Set the IP address of the computer to an unused one belonging to the same
network segment of the IP address of the camera but different from the IP
address of the camera.
The default login IP address of the camera is 192.168.1.203, and the DHCP
function is enabled. If there is a DHCP server in the network, the IP address of
the camera may be changed. Please refer to the actual IP address assigned to
the camera by the DHCP server.
General
3. Start a browser and enter the IP address of the camera in the address bar to
access the login page. Enter the User Name (default: admin) and Password
(default: admin123456), then click Login.
After successfully logging in to the web UI of the camera, you can start to configure
the camera as required.
Tips
For network security, after logging in to the web UI, please modify your username and password
in time. If your camera has been successfully managed by the NVR, modifying the login username
or password may cause the camera going offline. Please operate with caution.
Internet Protocol Version 4 (TCP/IPv4) Properties
You can get IP settings assigned automatically if your network supports this
capability. Otherwise, you need to ask your network administrator for the
appropriate IP settings.
Obtain an IP address automatically
Use the following IP address:
IP address:
Subnet mask:
Default gateway:
Obtain DNS server address automatically
Use the following DNS server address:
Preferred DNS server:
Alternate DNS server:
Validate settings upon exit
192 . 168 . 1 . 10
255 . 255 . 255 . 0
OK
User Name
Password
Login
- 9 -
Advanced...
Cancel
English
Remember me