Klarstein ICE GALET Manual De Instrucciones página 27

TROUBLESHOOTING
Problem Potential cause
The ADD WATER Lack of water.
indicator lights
up.
The ICE FULL There is too much ice.
indicator lights up
No ice cubes inside.
or flashes.
he LIGHT and ICE The ambient
symbols will flash. temperature or the
water temperature in the
inner tank is too high.
Coolant runs out.
Motor of the cover is
defective.
A pipe in the cooling
system is clogged.
Ice making is too Something has blocked
slow. the hot air outlet.
The water temperature
in the inner tank is too
high.
The cooling system is
not working properly.
Water leakage. Drain plug not installed.
A pipe connection in the
device has come loose.
The seal has reached its
service life.
Possible solution
Stop the ice maker, add water then
press the "ICE"/"CLEAN" button
again to restart the machine.
Remove the ice cubes.
Remove possible obstacles from the
interior or clean the inside wall of the
ice holder.
Press the ICE button for 5 seconds.
Only use the device at an ambient
temperature of maximum 32 °C. Fill
in cold water.
Press the ICE button twice and
restart the ice making program. If the
problem recurs, have it checked by a
qualified technician.
The hot air outlet needs a ventilation
distance of more than 15 cm.
The water temperature must be
between 7-32 °C.
Have it checked by a qualified
technician.
Install the drain plug.
Have it checked by a qualified
technician.
Have it checked by a qualified
technician.
EN
27