Comunello LIWIN L40 Slim Instrucciones De Uso Y De Instalacion página 44

5.2 MINIMUM PANEL HEIGHTS
Refer to the table for the values of the minimum heights of the panels relative to the chain motors in the bottom hung inward
opening version.
Chain stroke "C"
5.3 OPERATING TEST
ATTENTION! Carry out the first maneuver of the window during the closing phase.
Press the control button and close the window, checking that:
a. The window is completely closed. If it is not, check that the gap between the window and the frame is bigger than or equal
to 0 mm. If necessary, insert spacers so as to obtain the correct gap.
b. The chain is perfectly vertical to the window frame. If necessary adjust the fixing bracket by using the screws and slots.
Having reached the correct closing position, press the control button and open the window in order to check that the actuator
runs freely over the full travel set up.
Having achieved the required opening run, press the control button again to close the window. Once the window has completely
closed, check that the screws, supports and fixings are tightened correctly, and that the seals are sufficiently compressed.
44
200 mm
250 mm
300 mm
350 mm
400 mm
500 mm
550 mm
600 mm
650 mm
700 mm
750 mm
800 mm
850 mm
900 mm
950 mm
1000 mm
INDICATION OF DIMENSIONS
Motor rotation pivot
50
Panel rotation hinge
13.5
H min panel
300 mm
440 mm
580 mm
715 mm
855 mm
1135 mm
1275 mm
1415 mm
1555 mm
1700 mm
1840 mm
1980 mm
2120 mm
2260 mm
2405 mm
2545 mm