AEG OSF6D12ES Manual De Instrucciones página 16

Problem
The compressor does not start im‐
mediately after pressing the "Frost‐
matic", or after changing the temper‐
ature.
Door is misaligned or interferes with
ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and ice.
Water flows on the rear plate of the
refrigerator.
There is too much condensed water
on the rear wall of the refrigerator.
Water flows inside the refrigerator.
Water flows on the floor.
16 ENGLISH
Possible cause
The door is not closed correctly.
The Frostmatic function is switched
on.
The compressor starts after a period
of time.
The appliance is not levelled.
You attempted to re-open the door
immediately after closing.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correctly.
The gasket is deformed or dirty.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Appliance is fully loaded and is set
to the lowest temperature.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
Food products prevent the water
from flowing into the water collector.
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
Solution
Refer to "Closing the door" section.
Refer to "Frostmatic function" sec‐
tion.
This is normal, no error has occur‐
red.
Refer to installation instructions.
Wait a few seconds between closing
and re-opening of the door.
Close and open the door.
Contact the nearest Authorized
Service Centre.
Refer to "Closing the door" section.
Refer to "Closing the door" section.
Wrap the food products better.
Refer to "Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
This is correct.
Open the door only when necessa‐
ry.
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
Make sure that food products do not
touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.