Publicidad
Idiomas disponibles
Idiomas disponibles
3.4. Measurement
1.
Before turning the equipment on, connect the test probes to the item
to be measured and to the front panel terminals, as shown in figure 2
for current up to 10 A or in figure 3, for the 200 A range.
2.
Using the Range selector
use.
3.
Choose the power supply to use. If you are going to use the battery,
advance to the following point. If you are going to use the mains
supply, plug the power cord into the connector
The clamps in the drawings are only for illustration.
, choose the range and the current to
9
.
Publicidad
