Publicidad
Idiomas disponibles
Idiomas disponibles
Operating sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door.
P1104
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Press the ON/OFF button
comes on.
6. Select the drying programme or time.
7. If required, press the low temperature button
and/or the buzzer OFF button
8. Press the Start button
comes on and drying starts.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light
laundry after this phase.
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing phase
(duration: 30 minutes maximum).
The buzzer sounds every 10 seconds (if the
button has not been pressed).
Lights
and
flash alternately.
If you do not remove the laundry, the dryer will
stop automatically at the end of the anti-creasing
phase.
Light
flashes and the mains-ON light stays
on.
Turn the programme selector dial to "0"; light
goes out.
P1108
: the mains-ON light
.
for 2 seconds: light
is on).
You may remove the
Release the ON/OFF button (the mains-ON light
goes out) and immediately remove the laundry.
After each use
• Turn the programme selector dial to "0".
• Switch the appliance off by releasing the ON/OFF
button
. The mains-ON light goes out.
• Clean the filters (see page 14).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
wait until the end of this phase
before removing the laundry. This will avoid a build-
up of heat inside the appliance.
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
"0". Select the new programme and press the Start
button
.
12
(cooling) and
Publicidad
