Glow Fire Inside 106 Instrucciones De Montaje página 10

Decorative Crystal Installation
A. Glass front must be removed and the appliance must be mounted in its final location
before the log-set and crystal are installed.
B. Remove the log-set (G) from the package, put it to the fireplace designed place. Fig 6-1.
C. To switch to clear crystals. Place the plastic tray ( H ) to the fireplace designed place. Then
carefully place the clear crystals ( I ) into the plastic strip Apply an even layer from side to side. Fig 6-2,
Fig 6-3.
Fig 6-1. (Log-set)
Fig 6-3. (Clear Crystals)
Operation
Read and understand this entire owner's manual, including all safety information, before
plugging in or using this product. Failure to do so could result in electric shock, fire, serious
injury, or death.
Power
Plug the power cord into a 220-240 Volt 15 Amp grounded outlet (see IMPORTANT SAFETY INFORMATION
on Pages 2 and 3). Make sure the outlet is in good condition and that the plug is not loose. NEVER exceed the
maximum amperage for the circuit. DO NOT plug other appliances into the same circuit.
Methods of Operation
This electric fireplace can be operated by the TOUCH CONTROL PANEL, located on the bottom right side
glass panel of fireplace, or by the battery-powered REMOTE CONTROL.
Before operating, please review the IMPORTANT SAFETY INFORMATION on Pages 2 and 3, and heed all
warnings.
Glow Fire GmbH, James-Franck-Straße 23, 12489 Berlin
Fig 6-2. (Plastic Strip)
10