Glow Fire Inside 106 Instrucciones De Montaje página 6

Front Glass Panel Removal
A. Take off the screws on both side.(Fig. 1-1 )
B. Carefully lift the front trim up and away from the appliance (Fig. 1-2 ). Place it face down on a soft, non-
abrasive surface.
C. Reverse these steps to install the front glass.
Wall Recessed Installation
A. Take off the screws (1 per side) from the sides of the fireplace. Set the screws aside (Fig. 2-1 )
B. Remove the two brackets and set them aside.(Fig. 2-2 )
Fig. 2-1
C. Power the fireplace by plug-into the wall receptacle.
D. Have two adult people to lift up the fireplace and insert it into the rough-in frame and then secure it by
installing 4 wood screws (B) through the holes (Fig. 2-3, Fig 2-4).
E. Put the decorative crystals or log-set to the ember bed, then re-install the front glass.
F. Reverse these steps to re-install front glass.
Fig. 2-3
Glow Fire GmbH, James-Franck-Straße 23, 12489 Berlin
Fig. 1-1 Fig. 1-2
Fig. 2-2
Fig. 2-4
6