Publicidad
Idiomas disponibles
Idiomas disponibles
EN
EN
BATTERIES
When replacing the batteries, the meter software version is
shown during a brief moment (Fig. 2).
When replacing the batteries and after switching on the unit, it
will be shown all the display segments (Fig. 1). After that, the
software version number will be shown (Fig. 2).
BATTERIES CHARGING STATUS
The meter shows the batteries charging status on the
display. If the meter does not switch on when pressing the
TRIP
BATTERIES OK
OPERATING MODE
IMPORTANT: Always read the instructions before first use.
EQUIPMENT HANDLING
1 ON/RESET
Press only once for swithching on the meter.
Press the button for setting to zero the partial meter which
is visualized in the upper digit line. If you are in "TRIP"
mode and you want to reset the counter visualized in the
lower digit line, after reseting the partial meter, you have
to press this button again.
4
841 810 R. 09/23
Samson Corporation • 90 Monticello Rd • N.C. 28787 Weaverville USA • Phone (828) 686-8511 • Fax (828) 686-8533 • www.samsoncorporation.com
ON/RESET button or switches off after being pressed,
replaced the batteries with new ones.
g
Kg
TRIP
BATTERIES
CHARGED
2. SELECT
Press to display the ''TOTAL'' or ''TRIP'' meter in the lower
digit line:
Fig. 1
g
Kg
TRIP
HALF
BATTERIES EMPTY
REPLACE THE BATTERIES
CONTADOR TRIP
COMPTEUR TRIP
CONTADOR TRIP
СЧЕТЧИК «TRIP»
CONTADOR TOTAL
COMPTEUR TOTAL
ANZEIGE GESAMTMENGE
CONTADOR TOTAL
СЧЕТЧИК ПОЛНОГО РАСХОДА
Fig. 2
g
Kg
TRIP METER
ANZEIGE TRIP
TOTAL METER
Publicidad
