Publicidad
Idiomas disponibles
Idiomas disponibles
FAULT
The beverage is not properly dis-
pensed into the Drink container.
Waste water is not properly emp-
tied into the drip tray.
Abnormal noises.
Abnormal power connectivity.
A L A RM PROMPT S
ERROR SOUND
2 beep sounds
3 beep sounds
5 beep sounds
6 beep sounds
7 beep sounds
8 beep sounds
10 beep sounds
12 beep sounds
14 beep sounds
15 beep sounds
NOTES: If the issue cannot be resolved, do not disassemble the machine. Please send to
after sales service center for service.
E NGL I SH
10
CAUSE
Drink container is not correctly
positioned.
Dispense valve abnormality
Excess water basin is not correct-
ly positioned.
Does remove the drink container.
Dispense valve abnormality.
Standard machine operation.
Power disconnects for under 30
seconds.
Power disconnects for over 30
seconds.
EXPLANATION
No water in the water tank or
clogged filter at the bottom of the
water tank.
Grinding chamber cover is not
installed or installed improperly.
Too much material overloads the
motor.
The upper water level electrode
sticks or places too much material.
Abnormal voltage signal.
Abnormal internal communication
interface.
Drink outlet is blocked or blocked by
other articles.
Mixing chamber temperature sensor
detection circuit failure.
Zero crossing signal loss.
Overtime heating of Mixing chamber.
SOLUTION
Place the drink container in
its correct position
Send to after sales service
center for service.
Place the excess water basin
in its correct position.
Remove the drink container.
Send to after sales service
center for service.
Occasional noise is normal.
After reconnecting to power,
operations will resume auto-
matically.
After reconnecting to power,
the machine will be reset.
The remaining ingredients
can be processed and
removed by pressing the
cleaning button. After clean-
ing, new ingredients may be
added.
SOLUTION
Add water in the water tank to the water
level mark to clean the filter mesh at the
bottom of the water tank.
Check whether the grinding cham-
ber cover is not tightly closed.
Reduce material and re-make
after cleaning the machine.
Clean the electrode or reduce the
amount of material.
Check whether the voltage is lower
than 160V or higher than 260V / use
stabilized power supply.
Send to after sales service center
for service.
Clean the drink outlet or send
to after sales service center for
service.
Send to after sales service center
for service.
Send to after sales service center
for service.
Send to after sales service center
for service.
Publicidad
