Kohler K-7702-CP Instrucciones De Instalación página 2

Turn the drain flange so the drain lever hole is facing either
forward for under-the-lavatory control, or toward the
desired location for countertop control. Carefully tighten the
locknut. Do not scratch the finish. Remove any excess putty
or sealant.
NOTE: Do not reposition the drain flange after you have
tightened the locknut.
Insert the stopper assembly into the drain flange. Choose
the long or short ball lever. Fit the short end of the ball lever
into the drain lever hole and under the stopper assembly
for regular installations. Fit the ball lever through the hole
in the stopper assembly for vandal-resistant installations.
Loosely secure in place with the knurled nut. Remove and
adjust the stopper assembly so the stopper lifts about 3/8"
when opened. Tighten the knurled nut. Do not scratch the
finish.
Install the ball to the ball lever for under-the-lavatory control
installations. Install the connecting link and "V"-clip to the
ball lever for countertop control installations. Complete
assembly of a countertop control installation according to
the instructions included with the lift rod and escutcheon.
Apply thread sealant to the tailpiece. Thread the tailpiece
to the drain body, and tighten securely.
For new installations, install the lavatory according to the
instructions packed with the lavatory.
Install the trap.
Inspect for leaks.
A
1032344-2-
Drain Body
Tail-
piece
2
Stopper Assembly
Drain Flange
Locknut
Ball Lever
Connecting
Link
Knurled Nut
Ball
V-
Clip
Kohler Co.