Descargar Imprimir esta página

Sony PS-X50 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

TONEARM
ASSEMBLY
AND
ADJUSTMENT
Do not connect the power cord or the connecting cords until the
assembly
and adjustments
are complete.
The following procedures should be performed on a level surface.
Be careful not to damage
the stylus
tip while
making
adjust-
ments.
When
a cartridge is replaced, readjustments
are required.
Preparation
© Secure the Tonearm
to the Arm Rest and set the Cueing Le-
ver to [ Y ].
@ Plug the Shell into the Tonearm
and turn the Locking Collar
counterclockwise
until the Shell is firmly locked.
© Insert and turn the Counterweight
counterclockwise
several
turns.
(The Tracking-force
Ring turns simultaneously.)
y Arm Rest
Counterweight
O Remove
the stylus guard, if fitted.
Longitudinal
balance
adjustment *1
O Be sure
that the Anti-skating
Compensator
is set
at "0".
Release the Tonearm
from the Arm
Rest.
Anti-skating
compensator
"o"
@ Turn the Counterweight
as required
until the Tonearm
is in
a horizontally balanced position.
© While holding the Counterweight at the balanced
position,
separately turn the Tracking-force
Ring until the "0" indication
meets the center line on the Tonearm.
Recheck the balance.
Center line
Do not move
the counterweight.
Tracking-force Ring
@ Secure the Tonearm
to the Arm
Rest again.
Tracking-force
adjustment *2
Turn the Counterweight
counterclockwise
so that
the
recom-
mended
tracking-force figure for your cartridge is aligned with
the center line on the Tonearm.
The maximum
tracking force
available is 2,5 grams.
Tracking-force ring will
turn at the same time.
Overhang
check
*3
For
the
customers
who
purchased
the
non-European
model:
Please
skip this section
and
proceed
with
the following
anti-
skating compensation.
Check that the stylus
overhang
is set correctly
by using
the
"235" Alignment
Protractor on the back of the rubber mat.
@ Place the rubber mat upside down.
@ Bring the Tonearm
above
the cross
point
of the two
fine
lines, and carefully lower the stylus on the cross point with the
Cueing Lever.
© Check to see that the Shell is parallel to the lines drawn on
the rubber mat
as shown
in the center
illustration.
If they are
parallel, the stylus overhang
is set correctly.

Publicidad

loading