Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
For your own safety, never connect plug to power source
outlet until all assembly steps are complete, and you have
read and understood the safety and operating instructions
LEG SET (FIG. A)
I
Separate all parts and group by size and style
NOTE : Finger tighten bolts and nuts when joining
parts
2
Use bolts (!), washers (2), and nuts (3) to assemble
the leg set parts
3
Attach a leg (4) to the tong top bracket (5). Attach the
next leg to the opposite end of the top bracket.
4.
Repeat'this assembly for the opposite side of the
leg set.
5.
Attach the completed leg set assemblies to the short
top brackets (6). Repeat on the opposite side
6
Insert bolt (7) into the recessed hole pad (8).
7.
Insert into the leg flange hole and tighten, using
washer (9) and nut (10) Repeat for the three other
kegs..
8.
Attach bottom brackets (11) between each leg.
9.
Attach the hooks (12) to the frame as desired. The
hooks are used to hold the fence, the blade wrenches,
and miter gauge
I0
Place the leg set on a level surface and tighten al!
nuts and bolts
Fig. A
SAW TO LEG SET (FIG. B)
1.
Before mounting the rip fence and miter gauge to the
saw top, invert the saw table so that it is facing the
floor.
2
Position the leg set upside down on the saw base
3.
Match the holes of the stand to the holes on the
bottom flange of the saw base
4
Secure the leg set to the saw base using bolts,
washers, and nuts
5.
When all bolts and nuts are tightened, carefully set the
saw in its upright position
6.
Position the saw on a clean, level surface
Fig. B
Leg set
mounting hole
Saw base
hole
11
Publicidad
