Denver DAB-34 Manual Del Usuario página 3

DENVER DAB-34
1. To activate auto scan, press and hold
the MENU/INFO button for longer
than 2 seconds, rotate the SEARCH
control to select "Full scan". And press
the SELECT button to con rm, the
display will show "Scanning..." together
with a slide bar that indicates the progress of the scan. (F.3)
2. All the stations that have been found will be stored automatically. To
explore and listen to the found stations, rotate the SEARCH control and
then press the SELECT button to con rm.
DAB Manual tune
1. To select manual tune, press and hold the MENU/INFO button for longer
than 2 seconds, rotate the SEARCH control to select "Manual tune".(F.4)
And press the SELECT button to con rm.
2. Rotate the SEARCH control to move through the DAB channels, the display
will show "5A to 13F" and their associated frequencies. (F.5)
F.4
DAB
< Manual tune >
FM radio
1. To select FM, press the MODE button, the display will show FM and the
frequency.
2. To activate auto search, press SELECT
button or rotate and hold the SEARCH
control anticlockwise or clockwise until
the radio starts to scan the frequency
band, the display will show "Scanning ..."
(F6) and it will stop automatically once a station has been found.
3. To search manually, rotate the SEARCH control to increment the frequency
by 0.05MHz. If reception is still poor adjust the position of the antenna or
try moving the radio to another location.
EN-3
F.3
Scanning . . .
F.5
Manual tune
< 5A 174.928MHz >
F.6
92.75MHz
Scanning . . .
DENVER DAB-34
RESET (AC OPERATION ONLY)
1. If moving the radio to another location in the country the pre-tuned and
stored DAB stations may no longer be available and it will be necessary to
reset the radio back to the factory settings.
2. With the unit switched on, press and hold the MENU/INFO button for
longer than 2 seconds and rotate the SEARCH control until the display
shows "System" and press the SELECT button to con rm.
3. Rotate the SEARCH control unit the display shows "Factory Reset", press
SELECT button to con rm. (F.7)
4. The display shows "Factory Reset <No> Yes", rotate the SEARCH control to
select "Yes", and press SELECT button to con rm. (F.8)
5. The radio will display "Restarting...." and the unit will then go into standby
mode.
Note: All stored programmed stations will be lost during reset.
F.7
System
< Factory Reset >
TECHNICAL SPECIFICATION
Rated voltage (adaptor) AC 100 – 240V~ 50/60Hz, 0.3A
Adaptor output DC 6V 1.5A
Power consumption 9 W
Rated voltage (radio) DC 6V (1.5V x 4 AA)
Audio output 2*2W RMS
Radio DAB 174-240MHz
FM 87.5-108MHz
Unit dimension : 230 (L) × 138 (H) × 89 (D) mm
Weight : 0.9 kg
***SPECIFICATION SUBJECT TO CHANGE WITHOUT FURTHER NOTICE.***
EN-4
F.8
Factory Reset ?
< No > Yes