Taurus OPTIMA GO 1500 Instrucciones De Uso página 8

INSTRUCTIONS FOR USE
BEFORE USE
• Make sure that all products' packaging has been
removed.
• Please read the "Safety advice and warnings" booklet
carefully before first use.
• Before using the product for the first time, clean the
parts that will come into contact with food in the manner
described in the cleaning section.
USE
• Extend the supply cord completely before plugging it in.
• Ensure the blade with the sealing ring and the jar base
is fixed properly to the jar (by turning clockwise) before
putting on the motor body. (Fig. 1).
• Place the jar onto the motor unit until it fits properly into
place (Fig. 2), or place the extra cup onto the motor until it
fits properly into place.
• Put the ingredients, after having first chopped into
small pieces, into the jar with liquid (do not exceed the
maximum marker).
• Put the lid on the jar; make sure it is properly fixed in
place.
• Put the measuring cup on the lid.
• Connect the appliance to the mains.
• If you wish to add more ingredients, pull out the
measuring cup.
• Add the ingredients and replace the measuring cup.
• To stop the appliance, set the speed back to "0".
• Turn the appliance on by using the speed selector knob.
• The illuminated ring comes on (L).
• To avoid a fierce start-up, it is advisable to start off from
the lowest speed position and, once the appliance has
been switched on, progressively increase the speed to
the desired position.
EXTRA CUP ACCESSORY
• Place the foods to proceed in the cup without its blades
in position.
• Once the food is in the cup, the blades set with the blade
fixing ring must be set. Then, place it in the motor body.
• Stop the appliance when the food reaches the desired
texture.
• Detach the extra cup from the motor body by lifting the
cup.
• Remove the blades set and put the extra cup lid.
ELECTRONIC SPEED CONTROL
• The speed of the appliance can be regulated by using the
speed selector knob (I). This function is very useful, as it
makes it possible to adapt the speed of the appliance to
the type of work that needs to be done.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Stop the appliance, selecting position 0 on the speed
selector knob.
• Unplug the appliance from the mains.
• Lift the jar from the motor body.
• Clean the appliance.
"PULSE / ICE CRUSH" FUNCTION
• The appliance works at the highest speed to achieve
optimal performance.
• This function gives optimal results for ice-crushing up to
desired snowy level.
• Turn the speed selector knob to the left to operate the
Pulse function (J).
• We recommend working by pressing the button in cycles
of 3 seconds and repeating the operation until you obtain
the desired result.
SAFETY THERMAL PROTECTOR
• The appliance has a safety device which protects the
appliance from overheating.
• If the appliance turns itself off and does not switch itself
on again, disconnect it from the mains supply and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again, seek authorised technical
assistance.
CLEANING
• Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry it.
• Do not use solvents or products with an acid or base pH,
such as bleach, or abrasive products, for cleaning the
appliance.
• Do not let water or any other liquid get into the air vents to
avoid damage to the inner parts of the appliance.
• Never submerge the appliance in water or any other liquid
or place it under running water.
• During the cleaning process, take special care with the
blades, as they are very sharp.
• It is advisable to clean the appliance regularly and
remove any food remains.