Publicidad
Idiomas disponibles
Idiomas disponibles
PLUMBING
UncUuded in the accessories suppfied with this machine are 2
inUethoses and 4 rubber washers. The straight end of these
hoses shouM be connected to the suppUy (fig. 1).
The 90 ° angUedend of these hoses shouM be connected to
the inUet v Nves on the back of the machine, using one of the
washers to make a water tight sen on each connection.
The cou#fings shouM be tightened by hand, a tooU shouM onUy
be used if a Ueakoccurs.
Do not use excessive force (see fig. 1).
Repair or repUacement of a part shouM be made onUyby a
quaflfied service technician to prevent personN injury or damage
to the machine, inUet v Nves are coUorcoded:
Red
= Hot
White = CoM
Connection
to the water
mains
Water pressure must range within the values indicated on the
data plate on the rear of your washer-dryer, if the water pipes are
new or left unused, then before connecting the machine run the
water until clear to remove
debris. Connect the inlet hose
to a cold water tap having a %"
BSP thread. Ensure that there
are rubber washers are at each
end of the inlet hose. The L-
Shaped
end goes on the
machine and straight ends on
the water faucets
Fig. ! - _,_t('Jv)i!){,
im_et at th_,
rear
top right
Note:
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates on the
hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts, wear or leaks are found.
PLL!NBING
You should carefully position the drain hose to avoid kinks and
ensure proper d rainage of the water (fig. 2-3-4-5).
The outlet end of the drain hose must be at least 25" (62 cm)
above the base of the machine. At this point it is possible for
the water to be discharged into a sink or drain pipe, but an air
break must be available at this 25" height to prevent the machine
from syphoning (see fig. 2-3 aside).
No more than 6" of the drain hose should be inserted in the
drain pipe.
IMPORTANT
make sure that the drain hose is not kinked and the water flow
has not been restricted.
Standpipe
drain system:
In RV installation needs a 1-1/2 inch (3.7 cm) diam.
standpipe with minimum carry away capacity of 7 gallons (31
liters) per minute or2" (5 cm) in home installation (fig.3- 4).
Floor Standpipe
drain:
Top of standpipe must be at least 25 inches (62 cm) high and
no higher than 34 inches (86 cm) from the bottom of
washer (A) (fig. 3-4).
Wall standpipe
drain:
25 inches (62 cm) min.; 34 inches (86 cm.) max
from end of drain hose to bottom of washer (B) (fig. 5).
ater
Out}
Fig. 2 - Drainage
t
Fig. 4 - Drah'Ja_#'
I'"
25"
• 34 .CHE.
i
i
i
i
i
i
i
Fig. 3 - Drainage
Fig. 5 - Drainage
www.aristonappliances.us
lnstructionsforinstallationanduse
7
Publicidad
