Dometic mobitronic P1150 Instrucciones De Uso página 16

Operation
The device has a plug for a connection to a 12 V cigarette lighter socket or a 12 V on-
board socket. Connect the middle pin (fig. 1 5, page 3) of the plug to the positive wire
(+) and the two side brackets (fig. 1 4, page 3) to the negative wire (–).
➤ Switch on the ignition.
➤ Connect the inverter to the 12 V cigarette lighter socket or the 12 V on-board socket.
➤ Connect the inverter to a power consuming device.
Using the USB connection
➤ Connect the consumer unit to be supplied power (mobile phone, camera, laptop) to the
inverter.
➤ Connect the inverter to the 12 V cigarette lighter socket or the 12 V on-board socket.
➤ Switch the power consuming device on.
7 Operation
I
NOTE
 You can operate the inverter with the engine running or switched off. How-
ever, do not leave the engine on while the inverter is in operation, since the
power supply to the 12 V socket could be interrupted when starting.
 When operating the inverter at high load for lengthy periods, it is advisable
to start the engine in order to recharge the vehicle battery.
7.1 Functional check
The green status LED (fig. 1 1, page 3) indicates that the inverter is working correctly.
The device switches off when, because the ambient temperature is too high, it heats up
to more than 50 °C.
If the inverter overheats, pull out the connection cable from the socket. After it cools down,
you can plug the inverter back in.
8 Cleaning and maintenance
!
WARNING! Danger of electrocution!
Always disconnect the mains plug before you clean and service the device.
A
NOTICE! Danger of damaging the device!
Never clean the device under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during cleaning as these
can damage the device.
➤ Occasionally clean the device with a damp cloth.
16
PI150
EN