EINHELL TP-MG 18 Li BL Manual De Instrucciones página 12

•
Close the quick-release lock for changing
tools (5) again. Take care that the pins of the
chuck (2) remain in the recesses in the plug-
in tool.
•
The equipment comes with a disk (15)
for safely securing universal plug-in tools
with recesses. Please note the correct use
(camber facing the tool) of the disk (15) for
plug-in tools with recess as shown in Fig. 4
and 5.
Check that the plug-in tool is secure.
5.2 Triangular sanding/grinding plate
Fit the triangular sanding/grinding plate to use the
equipment as a triangular sander/grinder.
5.2.1 Fastening the sanding/grinding paper
The hook-and-loop fastener enables easy
changing of the abrasive paper. Make sure that
the vacuum extraction holes on the abrasive
paper and the grinding/sanding disk are aligned.
6. Operation
6.1 Switching on and off (Fig. 7)
Slide the switch (1) forward to switch on the
equipment.
Slide the switch (1) to the rear again to switch off
the equipment.
6.2 Practical tips
•
Switch on the equipment.
•
Work away from the body.
•
Never move your hands into the direct vicinity
of the work area.
•
Use only plug-in tools which are in good
working order and undamaged.
Plug-in tools:
Sawing: Sawing wood and plastic.
Notes on working practice:
When sawing, watch out for foreign bodies in the
material and remove them if necessary.
Plunge cutting is allowed only in soft materials
such as wood or plasterboard.
Sanding/grinding: Surface sanding/grinding
at edges, in corners or hard-to-reach areas.
Depending on choice of abrasive paper for the
sanding/grinding of wood, paint, lacquer, etc.
Anl_TP_MG_18_Li_BL_SPK7_NA.indb 12 Anl_TP_MG_18_Li_BL_SPK7_NA.indb 12
EN
Notes on working practice:
This equipment off ers particularly high
performance for the grinding/sanding of hard-to-
reach corners and edges. To grind/sand profi les
and channels you can also work with just the tip
or the edge of the grinding/sanding disk. Various
grinding/sanding papers are available, especially
designed for the diff erent types of material you
may be working on and the amount you wish to
remove from the surface. The amount removed
will depend largely on the choice of sanding/
grinding paper and pressure applied to the
sanding/grinding disk.
Scraping: Scraping off old paint or adhesives.
Notes on working practice:
Move the plug-in tool against the area you want to
remove. Begin with a fl at angle of incidence and
little pressure. The surface (e.g. wood, plaster)
may be damaged if too much pressure is used.
6.3 Speed control (Fig. 7)
You can select the speed by turning the speed
controller (4).
Plus direction: Higher speed
Minus direction: Lower speed
6.4 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.5 Battery capacity indicator (Fig. 8 / item 6)
Press the battery capacity indicator switch (7).
The battery capacity indicator (6) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
- 12 -
19.10.2023 10:32:42 19.10.2023 10:32:42