Olimpia splendid 9K-12K Instrucciones Para El Uso Y El Mantenimiento página 34

TEST OPERATION
Test Run Instruction
1. Turn on the power supply.
2. Press the ON/OFF button on the remote controller to turn on the air conditioner.
3. Press the Mode button to switch the mode COOL and HEAT.
In each mode set as below:
COOL-Set the lowest temperature
HEAT-Set the highest temperature
4. Run about 8 minutes in each mode and check all functions are properly run and respond the
remote controller. Functions check as recommended:
4.1 If the outlet air temperature respond the cool and heat mode
4.2 If the water drains properly from the drainage hose
4.3 If the Louver and deflectors(optional) rotate properly
5. Observe the test run state of the air conditioner at least 30 minutes.
6. After the successfully test run, return the normal setting and press ON/OFF button on the remote
controller to turn off the unit.
7. Inform the user to read this manual carefully before use, and demonstrate to the user how to use
the air conditioner, the necessary knowledge for service and maintenance, and the reminder for
storage of accessories.
Note:
If the ambient temperature is excess the range refer to section OPERATION INSTRUCTIONS, and it
can not run COOL or HEAT mode, lift the front panel and refer to the emergency button operation
to run the COOL and HEAT mode.
32